300 V6-3.5L (2008)
7. Position the blend door actuator (1) into the vehicle.
8. Install the blend door actuator onto the passenger side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align
the splines on the actuator output shaft (3) with those on the blend door cam (4).
9. Install the screws (1) that secure the blend door actuator (2) to the air distribution housing (3). Tighten the screws to 2 Nm (17 in. lbs.).
10. Connect the HVAC wire harness connector (4) to the blend door actuator.
11. Install the glove box into the instrument panel See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Instrument
Panel Glove Box - Installation.
12. Reconnect the negative battery cable.
Mode Door Actuator - Removal
REMOVAL
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury or death.