300 V6-3.5L (2008)
1. Install the air door(s) (1) into the air distribution housing (2) as required. Align the air door with the pivot shaft hole in the housing.
2. Align and install the air door lever (4) into the pivot shaft of the air door. Make sure that the tab (3) on the door lever is securely engaged to the
pivot shaft.
3. Align the air door pivot shafts with the pivot holes in the center partition (3) and install the partition onto the left half of the air distribution
housing (1).
4. Align the air door pivot shafts to each other and carefully install the left half of the air distribution housing to the right half of the housing (2).
5. Install the screws (4) that secure the two halves of the air distribution housing (3) together. Tighten the screws to 2.2 Nm (20 in. lbs.).
6. Inspect the foam seal (1), especially at the parting line (2). If the seal is deformed or damaged, it must be replaced.