300 V6-3.5L (2008)
5. Install the two intermediate shaft dash seal mounting nuts and tighten to 7 Nm (62 in. lbs.).
6. Raise and support the vehicle. See: Wheels and Tires/Vehicle Lifting/Service and Repair
7. Align the pin on the intermediate shaft (1) with the nut in the lower coupling shaft (2) and slide the intermediate shaft into the lower coupling.
8. Install a NEW steering coupling pinch bolt (3) at the intermediate shaft. Tighten the pinch bolt to 31 Nm (23 ft. lbs.).
9. Lower the vehicle.
10. Remove the steering wheel holder.
11. Check operation of the steering column for binding or noises.