300 V6-3.5L (2008)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
10. Using Puller (2), Special Tool 9360, separate upper ball joint stud (1) from knuckle.
11. Remove nut (4) from end of upper ball joint stud (1).
12. Pull shock assembly (3) downward until studs clear shock tower (2), then pull it outward allowing access to upper control arm mounting bolts.
13. Export Only - If servicing right upper control arm, disconnect headlamp leveling sensor (2) link at upper control arm (1).