300 V6-3.5L (2008)
1. Place link in bracket on crossmember (1). Install bolt and nut (4) at crossmember (1) as shown. Do not tighten bolt at this time.
2. Install bolt and nut (4) mounting link to knuckle (3) as shown. Do not tighten bolt at this time.
3. Install shock absorber (3) by setting lower end into pocket in spring link (4), then tipping top inward until aligned with upper mounting holes.
4. Install lower shock mounting bolt and nut. Do not tighten at this time.
5. If vehicle is equipped with AWD, make sure spacers (1) on top of crossmember mount bushings (2) on side of repair are in position.
