300 V6-3.5L VIN G (2005)
4. Remove screw (3) fastening wheel speed sensor to knuckle (1). Pull sensor head (4) out of knuckle.
5. Remove wheel speed sensor cable routing clip (2) from brake hose routing bracket (5).
INSTALLATION
1. Install wheel speed sensor head (4) into knuckle and install mounting screw (3). Tighten screw to 11 Nm (95 inch lbs.) torque.
2. Attach wheel speed sensor cable and routing clip (2) to brake hose routing bracket (5).
3. Attach sensor cable routing clip (2) to brake hose bracket (3).
4. Connect sensor connector (1) to body wiring harness connector (4). When installing connector, make sure retaining clip on body connector is
properly in place and sensor connect cannot be pulled out.
5. Lower vehicle.
6. Perform Verification Test and clear any faults.