300 SRT-8 V8-6.1L (2008)
Cowl Moulding / Trim: Service and Repair
Cowl Top Panel - Removal
REMOVAL
1. Remove the two push pins (2) that secure the front cowl top panel (1) to the right rear corner of the engine compartment
2. Remove the front cowl top panel.
3. Remove the windshield wiper arms See: Wiper and Washer Systems/Wiper Arm/Service and Repair/Wiper Arms - Removal.
4. Remove the push-pin (2) that secures each end of the cowl top panel (1) to each front fender (7).
5. Disengage the two 1/4-turn fasteners (3) that secure the cowl top panel to the dash panel (5).
6. Remove the six push-pins (4) that secure the cowl top panel to the strut tower support (6).
7. Disengage the integral retaining clips that secure the cowl top panel to the dash panel and remove the cowl panel from the engine compartment.
