300 SRT-8 V8-6.1L (2008)
Antenna Control Module: Service and Repair
Removal
REMOVAL
SEDAN
1. Disconnect and isolate the battery negative cable.
2. Remove C-pillar upper trim.
3. Disconnect wire harness connectors and antenna cable.
4. Remove mounting fasteners and antenna module.
WAGON
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. See: Starting and
Charging/Battery/Service and Repair/Procedures/Battery Reconnection.
1. Disconnect and isolate the battery negative cable.
2. Remove the liftgate trim.
3. Disconnect wire harness connectors and antenna cable.
4. Remove mounting fasteners and antenna module.