300 SRT-8 V8-6.1L VIN W (2005)
Front Door Panel: Procedures
CAUTION: Do not allow the watershield or adhesive to become contaminated with dirt or other foreign substances. Do not damage the watershield
during removal and installation. If the watershield becomes contaminated or damaged, replace the watershield.
REMOVAL
1. Remove the trim panel from the inside of the front door.
2. Carefully separate the lower half of the watershield (2) from the inside of the door (1).
3. Lift the lower half of the watershield upward far enough to access and pull the trim panel take outs of the door wire harness out of the slit near the
center of the watershield.
4. Carefully separate the upper half of the watershield from the inside of the door.
5. Lift the upper half of the watershield upward far enough to disengage the inside latch lock knob and link and the inside remote latch release handle
link from the slit near the upper rear corner of the watershield.
6. Remove the watershield from the door.
INSTALLATION
1. Thread the inside latch lock knob and link and the inside remote latch release handle link through the slit near the upper rear corner of the
watershield (2).
2. Place the front and rear dimple formations located in the upper watershield into their respective locator holes in the door (1) inner panel.
3. Apply firm and even pressure to the adhesive bead along the upper edge of the watershield to seal it to the inside of the door.
4. Lift the lower half of the watershield upward far enough to access and pull the trim panel take outs of the door wire harness out of through the slit
near the center of the watershield.
5. Apply firm and even pressure to the adhesive bead along the remaining edges of the watershield to seal it to the inside of the door. Be certain that
the watershield is sealed to the inside of the door.