300 SRT-8 V8-6.1L VIN W (2005)
10. Remove the screw (1) that secures the top of the rear regulator rail (2) to the inside of the door.
11. Remove the screw (4) that secures the regulator motor support bracket to the inside of the door.
12. Loosen the screw that secures the bottom of the regulator rail to the keyed hole (3) on the inside of the door.
13. Lift the rear regulator rail upward within the door far enough to disengage the screw from the keyed hole in the door.
14. Lower the rear regulator within the door (3) far enough to access and disconnect the door wire harness connector (1) from the regulator motor (2)
through the large access hole on the inside of the door near the front.
15. Remove the regulator through the large access hole on the inside of the door.
INSTALLATION