300 SRT-8 V8-6.1L VIN W (2005)
3.
Apply the grease to the left slide surfaces on all sides of the part, in the areas identified, (Fig. 2). There are 4 slide surfaces on each side of the
sunroof.
4.
Repeat steps 2 and 3 for the right side sunroof slide.
5.
Install the sunroof glass using the procedures outlined in the service information on TechCONNECT 23-Body/Sunroof/Glass
Panel/Glass/Installation.
6.
Cycle the sunroof to verify that squeak is eliminated.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
FAILURE CODE
Disclaimer
This bulletin is supplied as technical information only and is not an authorization for repair.