300 SRT-8 V8-6.1L VIN W (2005)
5. Remove four power brake booster (3) mounting nuts (1).
6. Remove two nuts (1) fastening pedal bracket to upper dash panel (2).
7. Push power brake booster (3) forward into engine compartment as far as possible by hand. Do not force it.
8. Remove brake pedal (4).
INSTALLATION
1. Install adjustable brake pedal assembly (4) under instrument panel and slide over booster push rod.
2. From engine compartment side, push power brake booster (3) mounting studs back through dash panel (2) and brake pedal bracket.
3. Install two upper mounting nuts (1) fastening pedal bracket to upper dash panel (2). Do not tighten at this time.
4. Install four power brake booster mounting nuts (1). Tighten nuts to 25 Nm (19 ft. lbs.) torque.
5. Tighten two upper mounting nuts (1) to 25 Nm (19 ft. lbs.) torque.
6. Slide booster push rod (5) onto brake pedal pin (4). Install NEW retaining clip (3) securing push rod to brake pedal.
7. Install and adjust NEW brake lamp switch (2).