300 SRT-8 V8-6.1L VIN W (2005)
4. Install upper end of brake pad spring clip (2) under upper brake pad support pin (1).
5. Press on lower end of spring clip (5) until it touches brake rotor.
6. Slide lower brake pad support pin (2) through caliper (1) and lower holes in both brake pads (3) in the same manner the upper pin was installed.
Ensure small end of support pin is in hole (4) in outboard half of caliper.
7. Release the spring clip allowing it to engage lower support pin.
8. From inboard side, seat upper and lower support pins (4) into caliper (3) using pin punch (1) and hammer (2). Support pins must be driven into
caliper until support pin retaining rings are locked into place.