300 SRT-8 V8-6.1L VIN W (2005)
5. Remove caliper mounting bolts (1).
6. Remove brake caliper (2) with pads from knuckle (8) and brake rotor (3). Hang assembly out of way using wire or a bungee cord. Use care not to
overextend brake hose when doing this.
7. Remove any clips (4) retaining brake rotor (3) to wheel studs.
8. Slide brake rotor (3) off hub and bearing (7).
REAR - SRT8
NOTE: Before proceeding, Refer to Service Precautions.
1. Raise and support vehicle.
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
CAUTION: When pushing pistons back into caliper bores, use only a trim stick as shown or other suitable soft tool. Never use a screwdriver or
other metal pry bar due to potential damage to braking surface of rotor, caliper, pistons or dust boots.