300 SRT-8 V8-6.1L VIN W (2005)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
ICU-Removal and Installation
ICU (INTEGRATED CONTROL UNIT)
REMOVAL
NOTE: Before proceeding, Refer to WARNING and CAUTION.
1. Disconnect and isolate battery negative cable (2) from battery post.
2. Using a brake pedal holding tool, depress brake pedal past its first inch of travel and hold it in this position. Holding pedal in this position will
isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open.
3. Remove brake tubes (1, 2, 3 and 10) at hydraulic control unit (5).