300 SRT-8 V8-6.1L VIN W (2005)
NOTE: Before installing booster, make sure there is a NEW booster seal (2) placed over push rod and mounting studs on rear of booster (1).
1. Install power brake booster through opening between cross-brace and windshield. Guide booster (1) push rod and mounting studs through dash
panel (2).
NOTE: Be sure to tighten all four booster mounting nuts to specifications or a vacuum leak can result.
2. Install four power brake booster mounting nuts (4). Tighten nuts to 25 Nm (19 ft. lbs.) torque.
3. Slide booster push rod (5) onto brake pedal pin (4). Install NEW retaining clip (3) securing push rod to brake pedal.
4. Install and adjust NEW brake lamp switch (2).