300 SRT-8 V8-6.1L VIN W (2005)
CAUTION: Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.
CAUTION: DO NOT allow other components including the wire harness to rest on or against the engine cylinder head cover. Prolonged contact with
other objects may wear a hole in the cylinder head cover.
1. Clean cylinder head cover (1) and both sealing surfaces (1,4,). Inspect and replace gasket (2) as necessary.
2. Install cylinder head cover and hand start all fasteners. Verify that all double ended studs (3) are in the correct location.
3. Tighten cylinder head cover bolts and double ended studs to 8 Nm (70 inch lbs.). Begin torque sequence in the middle of head cover and torque
bolts moving outward in a crisscross pattern from top to bottom.