300 SRT-8 V8-6.1L VIN W (2005)
1. Install valve seal.
NOTE: The intake spring damper has a longer free length compared to the exhaust spring damper.
2. Install valve spring.
3. Using special tool# 9065 (1,3,), compress valve spring and install valve spring retainer and locks.
4. Release air charge in cylinder (1).
5. Remove spring compressor tool # 9065 (3).
CAUTION: Verify that the pushrods are fully seated into lifter and rocker arm. Recheck after rocker arm shaft has been torqued to specification.
6. Install rocker arm shaft and pushrods.
7. Tighten the rocker shaft bolts to 22 Nm (195 inch lbs.) torque, using the rocker shaft torque sequence.