300 SRT-8 V8-6.1L VIN W (2005)
13. Remove the two screws (1) that secure the air distribution housing (2) to the rear of the HVAC housing (3).
14. Tilt the top of the air distribution housing rearward to disconnect the distribution housing from the tab-and-slot type retainers located at the bottom
of the housing.
15. Disconnect the air distribution housing from rear floor distribution ducts.
16. Remove the air distribution housing from the vehicle.
17. If required, disassemble the air distribution housing.
INSTALLATION
NOTE: The air distribution housing must be removed from the HVAC housing and disassembled for service of the mode-air and blend-air doors.
1. Position the air distribution housing (1) into the vehicle.
2. Install the air distribution housing onto the rear of the HVAC housing (2) by inserting the tabs on the bottom of the distribution housing into the
slots located on the bottom of the HVAC housing and tipping the distribution housing forward until it is properly aligned with the HVAC housing.
3. Connect the floor distribution ducts to the air distribution housing.
4. Install the screws (3) that secure the air distribution housing to the HVAC housing. Tighten the screws to 2.2 N.m (20 in.lbs.).