300 SRT-8 V8-6.1L VIN W (2005)
Headlamp Control Module: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Disconnect the one electrical connector to the HID translator module (1).
3. Remove the one nut (2) holding the module (1) to the bracket.
INSTALLATION
WARNING: WHEN REPLACING THE HEADLAMP LEVELING MODULE/HID TRANSLATOR MODULE, THE SYSTEM MUST BE
CALIBRATED USING A SCAN TOOL.
1. Install the one nut (2) holding the module (1) to the bracket.
2. Connect the one electrical connector to the HID translator module.
3. Connect the battery negative cable.
4. Using a Scan Tool, calibrate the headlamp levelling system.