300 SRT-8 V8-6.1L VIN W (2005)
Headlamp Alignment Sensor: Service and Repair
Rear
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Unsnap the sensor link from the spring link (rear) (3).
4. Disconnect the electrical connector (2).
5. Remove the two fasteners to the sensor and bracket (1).
INSTALLATION
1. Install the fasteners to the sensor and bracket (1).
2. Connect the electrical connector (2).
3. Snap the sensor link onto the spring link (rear) (3).
4. Remove the vehicle from the hoist.
5. Connect the battery negative cable.
6. Using a Scan Tool, calibrate the headlamp leveling system.