300 SRT-8 V8-6.1L VIN W (2005)
8. Push the ignition switch/lock assembly (3) inward toward the bulkhead.
9. Remove the SKREEM mounting screw (1) on the ignition lock assembly and separate the SKREEM from the ignition lock assembly.
When a PCM and the SKREEM are replaced at the same time, perform the following steps in order:
10. Program the new PCM.
11. Program the new SKREEM.
12. Replace all ignition keys and program them to the new SKREEM.
INSTALLATION
When a PCM and the SKREEM are replaced at the same time, perform the following steps in order:
1. Program the new PCM.
2. Program the new SKREEM.
3. Replace all ignition keys and program them to the new SKREEM.
4. Position the SKREEM on the ignition lock housing and install the retaining screw (1).