300 SRT-8 V8-6.1L VIN W (2005)
Rear Defogger Relay: Service and Repair
REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Open the cover of the power distribution center (PDC) (1) located at the rear of the vehicle near the battery (2).
3. Remove the EBL relay (3) from the PDC.
INSTALLATION
1. Position the EBL relay (3) into the proper receptacle of the power distribution center (PDC) (1) located at the rear of the vehicle near the battery
(2).
2. Align the EBL relay terminals with the terminal cavities in the PDC receptacle and push down firmly on the relay until the terminals are fully
seated.
3. Close the cover of the PDC.
4. Reconnect the negative battery cable.