300 SRT-8 V8-6.1L VIN W (2005)
Brake Fluid Pressure Sensor/Switch: Service and Repair
BRAKE PRESSURE SENSOR - SRT8
REMOVAL
1. Disconnect wiring harness connector (4) from pressure sensor (3) below master cylinder (1).
2. Remove pressure sensor (3) from fitting in primary brake tube (2).
INSTALLATION
1. Install pressure sensor (3) into fitting on primary brake tube (2) below master cylinder (1). Tighten switch to 28 Nm (250 inch lbs.) torque.
2. Connect wiring harness connector (4) to pressure sensor (3).
