300 SRT-8 V8-6.1L VIN W (2005)
13. Using Puller (1), Special Tool 9360, separate tension strut ball joint stud (2) from knuckle.
14. Remove nut (3) from end of tension strut (2) ball joint stud.
15. Loosen nut (5) attaching ball joint stud to lower control arm (4). Back nut off until nut is even with end of stud. Keeping nut on at this location will
help keep end of stud from distorting while using Puller in next step.
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
16. Using Puller (1), Special Tool 9360, separate ball joint stud (2) from lower control arm.