300 SRT-8 V8-6.1L VIN W (2005)
NOTE: Prior to using Special Tool 9361, lubricate bolt (1) threads to provide ease of use and promote tool longevity.
7. Place NEW knuckle sleeve (2) onto Installer Bolt 9361-7 (1), and slide it up to Bolt's head.
8. Slide Bolt 9361-7 (1) with sleeve (5) through knuckle (2) and spring link ball joint (3) starting from knuckle forward end.
9. Install thrust bearing and nut (4) on end of Bolt.
10. While holding Bolt head (1) stationary, rotate Nut (4) (using hand tools) installing sleeve in knuckle. Install sleeve until Nut stops turning. Do not
overtighten Nut.
11. Remove special tool.
12. Install spring link-to-knuckle bolt (2) front-to-rear through knuckle and link, then install nut. While holding bolt head stationary, tighten nut to 138
Nm (102 ft. lbs.) torque.
13. Remove under-hoist utility jack or jack stand from under spring link.