300 SRT-8 V8-6.1L VIN W (2005)
4. Position Wrench (2), Special Tool 9362, on shock shaft retaining nut. Next, insert 8 mm socket though Wrench onto hex located on end of shock
shaft. While holding shock shaft from turning, remove nut from shock shaft using Wrench.
5. Remove clamp from bottom of coil spring and remove shock and lower isolator out through bottom of coil spring.
NOTE: If upper mount or coil spring needs to be serviced, proceed with next step, otherwise, proceed with step 8.
6. Remove upper mount (1) from shock shaft and coil spring.
NOTE: Prior to removing spring from compressor, note location of lower spring coil end in relationship to compressor to ease assembly of
components later.
7. Back off Compressor drive, releasing tension from coil spring. Push back compressor upper hooks and remove coil spring from Compressor.