300 SRT-8 V8-6.1L VIN W (2005)
Wheel Bearing: Service and Repair
Rear Suspension
REAR
HUB AND BEARING
REMOVAL
1. Raise and support vehicle.
2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
3. While a helper applies brakes to keep hub from rotating, remove hub nut (1) from the half shaft (2).
NOTE: In some cases, it may be necessary to retract caliper piston in its bore a small amount in order to provide sufficient clearance between shoes
and rotor to easily remove caliper from knuckle. This can usually be accomplished before guide pin bolts are removed, by grasping rear of caliper and
pulling outward working with guide pins, thus retracting piston. Never push on piston directly as it may get damaged.