300 SRT-8 V8-6.1L VIN W (2005)
Fluid Line/Hose: Service and Repair
Removal and Installation
TRANS COOLER LINES
REMOVAL
1. Remove upper radiator closure panels
2. Using Tool 8875A, remove transmission cooler lines from transmission cooler.
3. Raise vehicle on hoist.
4. Remove front transmission cooler lines from the thermal bypass valve block.
5. Remove rear transmission cooler lines from the thermal bypass valve block
6. Remove the transmission cooler lines from the transmission.
INSTALLATION
1. Install rear transmission cooler lines at transmission. Tighten fittings to 20 Nm (18 ft. lbs.).
2. Install rear transmission cooler lines to thermal bypass valve. Tighten fittings to 20 Nm (18 ft. lbs.).
3. Install front transmission cooler lines to thermal bypass valve. Tighten fittings to 20 Nm (18 ft. lbs.).
4. Install front transmission cooler lines into transmission cooler.
5. Lower vehicle.
6. Check transmission fluid level.