300 SRT-8 V8-6.1L VIN W (2005)
Valve Body: Service and Repair
Installation
INSTALLATION
1. Position the electrohydraulic unit in the transmission housing.
2. Insert selector valve (1) in driver of detent plate (2). When installing the electrohydraulic control module in the transmission housing, the plastic
part of the selector valve (1) must engage in the driver of the detent plate (2).
3. Install the Torx socket bolts (3) and torque to 8 Nm (71 inch lbs.).
4. Install a new oil filter (4).
5. Install oil pan (5) and torque the oil pan bolts to 8 Nm (71 inch lbs.).
6. Install the oil drain plug (8) with a new drain plug gasket (9). Torque the drain plug to 20 Nm (177 inch lbs.).
7. Install the guide bushing (2) into the transmission housing and install the bolt (11) to hold the guide bushing in place.