300 SRT-8 V8-6.1L VIN W (2005)
Drive/Propeller Shaft: Service and Repair
Installation - Rear
INSTALLATION - REAR
CAUTION: Propeller shaft installation is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while only connected
to the transmission or rear axle flanges. A helper is required. If a propeller shaft section is hung unsupported, damage may occur to the shaft, coupler,
and/or center bearing from over-angulation. This may result in driveline vibrations and/or component failure.
COUPLER/DAMPER SERVICE
1. If coupler and/or damper (V6 Models) were removed, align index marks and reinstall. Make sure protruding sleeve (2) is properly seated into
propshaft or damper counterbores.
2. Install three bolts with washers and nuts and torque to 58 Nm (43 ft. lbs.) torque.
1. Obtain helper and install propeller shaft into position at axle. Align index marks (3) placed upon removal. Install propeller shaft rear
coupler-to-axle flange bolt/nuts by hand. Do not torque at this time.