300 SRT-8 V8-6.1L VIN W (2005)
1. Slide new sealing boot (1) to interconnecting shaft retaining clamp onto interconnecting shaft. Slide the outer C/V joint assembly sealing boot onto
the interconnecting shaft. Seal boot MUST be positioned on interconnecting shaft so the raised bead on the inside of the seal boot is in groove on
interconnecting shaft.
2. Align splines on interconnecting shaft with splines on cross of outer C/V joint assembly and start outer C/V joint onto interconnecting shaft.
3. Install outer C/V joint assembly onto interconnecting shaft by using a soft-faced hammer (1) and tapping end of stub axle (with nut installed) until
outer C/V joint is fully seated on interconnecting shaft.
4. Outer C/V joint assembly must be installed on interconnecting shaft until cross of outer C/V joint assembly is seated against circlip on
interconnecting shaft (1).