300M V6-3.5L VIN G (2000)
34.
Disconnect the passenger airbag electrical connector.
35.
Disconnect the I/P wiring harness from the airbag reinforcement bracket.
36.
Remove the four (4) upper airbag module screws (2 per side) (Figure 2).
37.
Remove the five lower airbag module screws (Figure 2).
38.
Remove the passenger airbag module from the vehicle.
FIGURE 3
39.
Remove the four (4) airbag reinforcement bracket screws and remove the reinforcement bracket (Figure 3).
NOTE:
Do NOT attempt to deploy the airbag module. All airbag modules must be returned to the supplier.
40.
Install the reinforcement bracket on to the new airbag module (Figure 3). Tighten the screws to 20 in-lbs (2.3 N.m).
41.
Install the new passenger airbag module into the I/P.
42.
Install the five (5) lower airbag module screws (Figure 2). Tighten the screws to 20 in-lbs (2.3 N.m).
43.
Install the four (4) upper airbag module screws (2 per side) (Figure 2). Tighten the screws to 75 in-lbs (8.5 N.m).
44.
Connect the I/P wiring harness to the airbag reinforcement bracket.
45.
Connect the passenger airbag electrical connector.
46.
Install the right and left I/P passenger airbag module pencil struts (Figure 2). Tighten the nuts to 45 in-lbs (5.1 N.m).
47.
Install the right air distribution duct and install the two (2) air distribution duct screws. Tighten the screws to 20 in-lbs (2.3 N.m).
48.
Install the right demister duct and install the four (4) demister duct screws. Tighten the screws to 20 in-lbs (2.3 N.m).
49.
Move the I/P back into its original position.
50.
Install the three (3) upper right I/P mounting bolts (Figure 1). Tighten the bolts to 75 in-lbs (8.5 N.m).
51.
Install the three (3) lower right I/P mounting bolts (Figure 1). Tighten the bolts to 75 in-lbs (8.5 N.m).
52.
Connect the radio antenna connector.
53.
Connect the I/P to body harness electrical connector.
