Aspen 2WD V8-4.7L (2007)
Seat Heater: Service and Repair
Front Seats
Removal
REMOVAL
Do not remove the OEM heating elements (3) from the seat or seat back cushions. The original element is permanently attached and cannot be removed
without permanent damage. The replacement heating element is designed to be applied directly on the seat cushion.
1. Disconnect and isolate the negative battery cable.
2. Remove the appropriate seat cushion or seat back trim cover.
3. Disconnect the inoperative heated seat cushion or seat back element electrical connectors (2).
4. Locate the wires leading from the inoperative heating element and cut them off flush with the edge of the original heating element.
Installation
INSTALLATION
1. Peel off the adhesive backing on the back of the replacement heating element and stick directly on the foam cushion or directly on top of the
original heating element.