Aspen 2WD V8-4.7L Flex Fuel (2009)
improper service procedures.
6. On HEV models, reconnect the battery system using the service disconnect at the battery pack .
7. On gasoline only models, reconnect the negative battery cable.
8. Evacuate the refrigerant system See: Service and Repair/Refrigerant System Evacuate.
9. Adjust the refrigerant oil level See: Specifications/Capacity Specifications/Refrigerant Oil Capacity.
10. Charge the refrigerant system See: Service and Repair/Refrigerant System Charge.
Front
3.7L/4.7L ENGINES
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service
Precautions/Warning and See: Service Precautions/Caution . Failure to follow the warnings and cautions may result in possible
serious or fatal injury.
NOTE: 3.7L engine shown. 4.7L engine similar.
1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery.
3. Remove the air cleaner housing and resonator See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner
Housing/Service and Repair/Air Cleaner Body - Removal.
4. Remove the nut (1) that secure the A/C suction line (2) to the A/C compressor (4).
5. Disconnect the A/C suction line from the A/C compressor and remove and discard the O-ring seal and gasket.
6. Install plugs in, or tape over, the opened suction line fitting and the compressor port.
7. Raise and support the vehicle.
8. Remove the right front wheelhouse splash shield.
