Aspen 2WD V8-5.7L Hybrid (2009)
Windshield Washer Spray Nozzle: Service and Repair
Washer Nozzle - Removal
Front
FRONT
1. Insert a trim stick or another suitable wide flat-bladed tool between the front or rear edge of the washer nozzle (1) and the hood panel (2) to
depress one of the nozzle latches.
2. Holding the latch depressed, lift upward on the same edge of the nozzle to disengage it from the hood.
3. Pull the nozzle away from the hood far enough to access and disconnect the hose from the barbed nipple of the nozzle.
4. Remove the nozzle from the top of the hood panel.
Rear
REAR
NOTE: The rear washer nozzle latch feature is a one time component, and will be damaged if the nozzle is removed from its mounting hole for
service. If removed from its mounting hole for any reason, the rear washer nozzle must be replaced with a new unit.
1. Using a trim stick or another suitable wide flat-bladed tool, gently pry at the bottom of the rear washer nozzle (2) to release the latch feature that
secures it in the mounting hole of the liftgate outer panel (3).
2. Pull the rear washer nozzle out from the liftgate outer panel far enough to access the washer hose (1).
3. Disconnect the hose from the barbed nipple on the back of the nozzle.
4. Cut 4 to 6 millimeters (0.15 to 0.23 inch) from the end of the hose to ensure a good fit to the replacement washer nozzle.
5. Discard the nozzle.