Aspen 4WD V8-5.7L Hybrid (2009)
4. Using the sequence shown, install the intake manifold retaining bolts and tighten to 12 Nm (9 ft. lbs.).
5. Connect the fuel supply line quick connect fitting at the fuel rail (1) See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Line
Coupler/Service and Repair
NOTE: The factory fuel injection wiring harness is numerically tagged (INJ 1, INJ 2, etc.) for injector position identification. If the harness
was not tagged, use wiring location noted during removal.
6. Reposition the fuel injector wiring harness and connect the electrical connectors to all fuel injectors.
7. Position the EGR valve tube (2) and install the retaining bolts (1) and tighten to 13 Nm (10 ft. lbs.).
