Aspen 4WD V8-5.7L Hybrid (2009)
Dome Lamp Bulb: Service and Repair
Dome Lamp - Removal
Front
BULB - FRONT
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Remove the front dome lamp unit (2) from the headliner. See: Service and Repair/Dome Lamp - Removal.
3. With the lamp lens (1) in the open position, carefully unsnap the bulb (3) from the two bulb holders within the front dome lamp housing.
Rear
BULB - REAR
1. Disconnect and isolate the battery negative cable. On vehicles equipped with the optional Hybrid Electric Vehicle (HEV) system, a technician
trained in proper HEV service safety procedures must also remove the high voltage service disconnect from the high voltage battery pack.
2. Insert the tip of a small flat-bladed screwdriver into the notch on one side of the rear dome lamp between the lens (4) and the lamp housing (1).
3. Gently pry the notched edge of the lens downward until it unsnaps from the housing.
4. Swing the notched end of the lens downward far enough to access the bulb (3).
5. Carefully unsnap the bulb from the two bulb holders within the rear dome lamp housing.