Aspen 4WD V8-5.7L Hybrid (2009)
Seals and Gaskets: Service and Repair
Front Input Shaft Seal - Removal
REMOVAL
1. Remove the transfer case from the vehicle.See: Service and Repair/Removal and Replacement/MP3010 Transfer Case - Removal.
2. Remove the input shaft seal using Seal Remover 7794-A (1) and Slide Hammer C-637 (2).
Front Input Shaft Seal - Installation
INSTALLATION
NOTE: Lubricate all seals with MOPAR(R) ATF+4 prior to installation.
1. Using Driver handle C-4171 (1) and Seal Installer 8841 (2) install the front input shaft seal.
2. Install the transfer case into the vehicle.See: Service and Repair/Removal and Replacement/MP3010 Transfer Case - Installation
3. Check the transfer case fluid. See: Service and Repair/Procedures/MP3010 Transfer Case - Fluid Drain and Refill. Correct as necessary.
Front Output Shaft Seal - Removal
REMOVAL