Cirrus V6-2.5L VIN H (1995)
Cruise Control Servo: Service and Repair
1. Remove speed control cable and mounting bracket from servo.
2. Remove servo mounting bracket, then disconnect electrical and vacuum hose connections.
3. Pull cable away from servo to expose retaining clip, then remove clip attaching cable to servo.
4. Remove servo unit.
5. With throttle in full open position align hole in speed control cable sleeve with hole in servo pin, then install retaining clip.
6. Connect electrical and vacuum hose connections to servo.
7. Install servo studs through holes in speed control cable and mounting bracket.
8. Install nuts and torque nuts to 80 inch lbs.