Concorde V6-2.7L VIN R (1998)
Installation
1. Install exhaust manifold and gasket. Tighten bolts starting at the center working outward to 23 Nm (200 inch lbs.).
2. Install heat shields. Tighten screws to 12 Nm (105 inch lbs.).
3. Install oxygen sensor and connect electrical connector.
4. Raise vehicle on hoist.
5. Install bolt attaching transmission dipstick tube.
6. Replace the O-ring on engine oil dipstick tube and install tube.
7. Install catalytic converter.
8. Install a new V-Band clamp and tighten to 10 Nm (100 inch lbs.).
9. Install engine wiring harness support bracket to cylinder head and attach connectors to bracket.
10. Install exhaust system.
11. Connect negative cable.
