Concorde V6-2.7L VIN R (1998)
62.
Connect the brake switch electrical connector.
63.
Install the left (driver's) side air distribution ducts.
64.
Install the two (2) center I/P lower attaching nuts (Figure 1). Tighten the nuts to 75 in-lbs (8.5 N.m).
65.
For vehicles equipped without a center console only: Install the center lower I/P storage bin.
66.
For vehicles equipped with a center console only: Install the console to I/P center support bracket.
67.
For vehicles equipped with a center console only: Install the left console side trim panel.
68.
Connect the heater control and traction control electrical connectors and install the I/P center bezel.
69.
Install the left knee blocker.
70.
Connect the hood release cable and trunk release electrical connector and install the left lower I/P cover (Figure 1).
71.
Install the left I/P end cap (Figure 1).
72.
Install the upper I/P cover (Figure 1).
73.
Install the right and left A-Pillar trim panels.
74.
Install the right lower I/P trim panel/glove box compartment. Tighten the screws to 20 in-lbs (2.3 N.m).
75.
For vehicles equipped with a center console only:
A.
Install the right console side trim panel.
B.
Install the console shifter bezel.
C.
Install the gear shift handle and then tighten the gear shift handle set screw securely.
76.
Install the right I/P end cap (Figure 1).
77.
Install the four (4) screws that attach the glove box door to the I/P. Tighten the screws to 20 in-lbs (2.3 N.m).
78.
Turn the ignition switch to the ON position and exit the vehicle.
79.
Reconnect the negative battery terminal.
80.
From outside the vehicle, turn the ignition switch to the OFF position for about 10 seconds and then back to the ON position.
81.
Observe the airbag warning light in the instrument cluster. It should illuminate for 6-8 seconds and then go out.
NOTE:
If the airbag warning light fails to light or lights and stays on, there is a system malfunction. Refer to the proper Body Diagnostic Procedures manual
to diagnose and repair the problem.
Dealer Service Instructions
IMPORTANT
DEALER SERVICE INSTRUCTIONS
Safety Recall # 777 -- Passenger Air Bag Module
^
This service requirement applies only to certain 1998 model year Dodge Intrepid and Chrysler Concorde vehicles.
^
The passenger air bag module on the above listed vehicles may not contain some required components. To correct this condition, the passenger air
bag module must be replaced.
^
Dealers are encouraged to consider alternative scheduling and servicing approaches for this recall. This repair does not require hoists or other full
service facility special equipment and is a CHRYSLER MOBILE SERVICE approved repair.
Parts Packages: