Concorde V6-2.7L VIN R (1998)
3. Press lower control arm pivot bushing into lower control arm until Installer, Special Tool 6644-1 or equivalent squarely bottoms against surface of
lower control arm. When Installer, Special Tool 6644-1 or equivalent squarely bottoms on control arm, bushing is installed to the correct position
in control arm.
4. Install tension strut into the tension strut bushing in lower control arm. Position tension strut in lower control as shown, with word FRONT
stamped in tension strut positioned away from control arm. With an open end wrench on flat of tension strut to stop tension strut from turning.
Tighten the NEW tension strut to lower control retaining nut to a torque of 130 Nm (95 ft. lbs.).
5. Install lower control arm and tension strut as an assembly back on the vehicle.
