Concorde V6-2.7L VIN R (1998)
CAUTION: When removing outer C/V joint from hub and bearing assembly, do not allow the flinger disk on hub and bearing assembly to
become damaged. Damage to the flinger disk will cause dirt and water intrusion into bearing. Premature bearing failure will result.
Outer C/V Joint Removal From Hub And Bearing
12. Hold outer C/V joint assembly with one hand. Grasp steering knuckle with other and rotate it out and to the rear of the vehicle, until outer C/V
joint clears hub and bearing assembly.
Inner Tripod Joint Removal From Stub Shaft
13. Remove driveshaft inner tripod joint from transaxle stub shaft. When removing driveshaft, do not pull on interconnecting shaft to remove inner
tripod joint from stub shaft. Removal in this manner will separate the spider assembly from the tripod joint housing. Grasp inner tripod joint and
interconnecting shaft and pull on both pieces at the same time.
For axle shaft seal replacement, refer to Automatic Transmission / Seals and Gaskets / Service and Repair / Transfer Shaft Seal Replacement.
Installation
