Concorde V6-2.7L VIN V (2001)
**PARTS REQUIRED:
NOTE:
Each kit contains one handle/bezel assembly, six pushnuts and an instruction sheet.
SPECIAL TOOLS/EQUIPMENT REQUIRED:
REPAIR PROCEDURE:
1.
Remove the front door trim panel using the procedures outlined on TeChCONNECT or in Section 23 of the appropriate service manual.
2.
After placing the door trim panel on a clean work surface, use a 21/64 in. drill bit to drill out the mounting boss heat stakes that attach the existing
door handle/bezel to the trim panel. Take extra care to drill in the center of each heat stake, (Fig. 1).
3.
Remove the existing handle/bezel from trim panel.
4.
Clean the back of the trim panel of all plastic filings.
5.
Seat the new handle/bezel into position.
6.
Place the push nuts onto the handle/bezel bosses.