Concorde V6-2.7L VIN V (2001)
to give false readings. If this problem occurs, the compass variance setting may need to be changed.
To set the compass variance:
1. Using the Variance Settings map, find your geographic location and note the zone number.
2. Turn the ignition switch to the ON position. If the compass/thermometer data is not currently being displayed, momentarily depress and release
the C/T push button to reach the compass/thermometer display.
3. Depress the Reset push button and hold the button down until "VARIANCE = XX" appears in the display. This takes about five seconds.
4. Release the Reset push button. "VARIANCE= XX" will remain in the display. "XX" equals the current variance code setting.
5. Momentarily depress and release the Step push button to step through the zone numbers, until the zone number for your geographic location
appears in the display.
6. Momentarily depress and release the Reset push button to enter the displayed zone number into the EVIC module memory.
7. Confirm that the correct directions are now indicated by the compass.
Homelink(r) Universal Transmitter
The HomeLink Universal Transmitter is optional with the standard overhead console. For added security it will operate home security systems that
use coded signals known generically as rolling codes to increase security. The overhead console display provides visual feedback to the driver,
showing which HomeLink transmitter button is pressed. As on prior models, HomeLink can learn and store three separate transmitter radio
frequency codes to operate garage door openers, security gates, and security lighting. Buttons are marked with one, two or three raised dots for
identification by touch.
Self-Diagnostic Test
The self-diagnostic test is used to determine that the internal circuitry and compass are operating properly, and all PCI bus messages are being
received for initial operation. The button backlighting is also verified by flashing the bulbs for proper operation.
Initiate the self-diagnostic test as follows:
1. With the ignition switch in the OFF position, simultaneously press and hold the C/T button and the RESET button.
2. Turn the ignition switch to the ON position.
3. Continue to hold both buttons until the software versions are displayed.
4. The display will show the result of the self-diagnostic test. If the display reads:
a.
PASS SELF TEST - press the RESET button to return to the compass/temperature display. The EVIC is working properly.
b.
FAILED SELF TEST - an internal failure has occurred. Replace EVIC.
c.
FAILED J1850 COMMUNICATION - see diagnostics for further information,
