Concorde V6-2.7L VIN V (2001)
Power Mirror Switch: Testing and Inspection
Power Mirror Switch Test
1. Remove trim panel. Refer to Body, Door Front for Removal and Installation procedures.
2. Disconnect wire harness connector from back of power mirror switch.
3. Disengage lock tabs at both ends of switch and remove power mirror switch from door trim panel.
Mirror Switch Test
Fig.2 Mirror Switch Connector Pin Call-Out
4. Using an ohmmeter, test for continuity between the terminals of the switch as shown in the Mirror Switch Test table.
5. If test results are not obtained as shown in the Mirror Switch Test table, replace the switch.
