Concorde V6-2.7L VIN V (2001)
4. Install the brake pedal shaft.
5. Install the nut on the end of the brake pedal pivot shaft. Tighten the nut to a torque of 34 Nm (25 ft. lbs.).
6. Install the power brake booster input rod on the brake pedal pin.
CAUTION: When installing the retaining clip on the brake pedal pin, a NEW retaining clip must be used to ensure the retention of the power brake
booster input rod.
7. Install a new retaining clip on the brake pedal pin.
8. Using Mopar Lubriplate or an equivalent, lightly lubricate the surface of the brake pedal striker where the plunger of the brake lamp switch
contacts it.
NOTE: Prior to installing the brake lamp switch into its bracket, the plunger must be moved to its fully extended position using the procedure in Step
9.
9. Hold brake lamp switch firmly in one hand. Using other hand, pull outward on the plunger of the brake lamp switch until it has ratcheted out to its
fully extended position.
10. Install the brake lamp switch in the brake pedal bracket. Install it using the following procedure. Depress the brake pedal as far down as possible.
Then while holding brake pedal down, align the index key on switch with notch in square hole of mounting bracket, When the switch is fully
installed into the bracket, rotate the switch in a clockwise direction approximately 30 degrees until it locks into place.
CAUTION: Do not use excessive force when pulling back on brake pedal to adjust the brake lamp switch. If to much force is used, damage to the
brake lamp switch or striker can result.
11. Gently release/pull back the brake pedal until it stops moving. This will cause the switch plunger to ratchet back to its correctly adjusted position.
12. Connect the remote ground cable to the ground stud on the right front strut tower.
13. Check the operation of the brake lamps.
