Concorde V6-2.7L VIN V (2001)
Oil Filter: Service and Repair
REMOVAL
1. Remove oil filter using suitable oil filter wrench (Fig. 92). Dispose of oil filter following environmental guidelines.
INSTALLATION
1. Wipe filter base clean, then inspect gasket sealing surface.
2. Lubricate gasket of new filter with clean engine oil.
3. Install oil filter (Fig. 92) and tighten to 16 Nm (12 ft. lbs.) of torque after gasket contacts base. Use filter wrench if necessary.
4. Fill crankcase with proper engine oil to correct level if drained. Start engine and check for leaks.