Concorde V6-2.7L VIN V (2001)
Intake Manifold: Service and Repair
Upper Intake Manifold
REMOVAL - UPPER
1. Disconnect negative cable from battery remote jumper terminal.
2. Remove air inlet resonator and inlet tube.
3. Remove throttle cable and speed control cable from throttle arm and bracket.
4. Remove throttle cable bracket.
5. Disconnect electrical connectors from the following components:
-
Manifold Absolute Pressure (MAP) Sensor
-
Intake Air Temperature (IAT) Sensor
-
Throttle Position Sensor (TPS) Sensor
-
Idle Air Control (IAC) Motor
-
Manifold Tuning Valve (MTV) - (if equipped)
6. Disconnect Vapor Purge hose, Brake Booster hose, Speed Control Servo, Positive Crankcase Ventilation (PCV) hose (Fig. 107).
7. Remove EGR upper tube.
8. Loosen upper fastener at throttle body support bracket.
9. Remove engine name cover from manifold by applying upward pressure to release retaining clip.